Dyno results: Golf GTI 2.0 TSI Stage 1
A 2.0 TSI on our rollers before and after a Stage 1 calibration: what the curve shows and how the car behaves on the road.
By RevX Workshop

The car
A 2019 Golf GTI, 2.0 TSI, manual, running 99 RON with a standard intake and exhaust and a fresh service.
Before
The baseline pull confirmed the factory figures: 230 bhp and 350 Nm, with the usual flat spot below 2,200 rpm and torque tapering early in the rev range.
After
A Stage 1 calibration produced 297 bhp and 450 Nm — an increase of 67 bhp and 100 Nm, broadly in line with what we see across this engine family.
What the curve tells you
The numbers matter less than the shape. Almost the entire gain sits between 2,200 and 5,500 rpm, which is exactly where you use a road car. Peak power rises, but the mid-range lift is what you feel.
On the road
The car pulls cleanly from low revs in third and fourth, needs fewer downshifts on A-roads, and still behaves in traffic. That is what a well-written file should feel like.
A note on estimates
Our vehicle scanner shows typical results for an engine, not a guarantee. Real output depends on fuel, health, ambient temperature and hardware — and we always confirm with a logged run before handover.
Ready to calibrate your car?
Check the estimated gains for your vehicle, or send us a request and we will confirm what is possible.